*carbon bearings are standard on some meter sizes of this class, please consult factory.

*10PPR DRY REED PULSER

MSAA120P1 METER LESS REGISTER AND GEAR PLATE

MSAA120S1 METER WITH POD (PULSE OUTPUT DEVICE)

MSAA120P2 METER LESS REGISTER AND GEAR PLATE

MSAA120S2 METER WITH POD (PULSE OUTPUT DEVICE)

Use the chart below to determine maximum meter flow rate relative to meter bearing material and product viscosity:

1. Determine the percent of rated capacity at which the meter will be required to operate;
2. Determine product viscosity at system operating temperature;
3. Plot the point on the chart where the two lines intersect;
4. Determine the meter bearing material from construction/application table above and locate the corresponding slope on the chart.

If the plotted point is above the bearing material slope, you are outside the allowable pressure loss for the specified meter and bearing. You should either chose a larger meter, reduce flow rate, or consider alternative bearing materials.